Případové studie

Our AIS EURELO case studies will give you an insight into the work we do and the customers we’ve helped.

Stolle Machinery

We recently completed a three-month project for Stolle Machinery with OEM, Goss International, to remove three large web offset printing presses from the ex Polestar Print facility in Sheffield.

Our scope of works included:

  • Full project management and CDM management
  • Electrical and mechanical services
  • Installation of over 20km of process pipework
  • Rigging and lifting of machinery, equipment and transport
  • Installation of a mezzanine floor and platforms at a weight of approximately 250 tonnes


Goss International

We recently completed a successful 12-month, £4.5m ‘Turnkey Installation’ of a canning plant for leading food and beverage can makers, Stolle, in Germany.

One printing press was destined for a new facility in Yorkshire, while the remaining two were to be reinstalled elsewhere in Europe.

To facilitate this our activities included:

  • Meticulously planning for lifting three presses with a combined weight of more than 1350 tonnes
  • Technical meetings and risk assessments to aid planning and ensure safety
  • Lifting of each section of the presses from its plinth using jacking systems
  • Skating of each section to the building’s exit
  • Lifting of each press onto its transportation, ready for the next stage of the journey
  • Deployment of two Forklift Trucks, a Valla Mini Crane, an Ormig Mini Crane, 60/80 Versa Lift and Machine Moving Skates
  • Use of a 220te mobile crane to complete some of the final lifts onto the low loaders
  • Careful movement of the dryer section of each press, which measured over sixteen metres long and four metres wide and weighed forty-three tonnes. Due to a decline on the road at the exit of the building the dryer could only be skated less than a metre at a time before it need to be raised on chocs to enable it to stay parallel, ready for the final lift and rotation onto the back of the low loader


We were commissioned as the principal CDM contractor of a ten month, £4.2m project for the removal of 83 heavy blanking and forming presses for export to China.

Our scope of works included:

  • Removal of all tool room machinery
  • Full isolation and lock off procedure
  • Site wide safety that exceeded ‘Ford’ standards
  • Dismantling and removal of 83 presses
  • Removal of all assembly cells including all robots and tooling
  • Site-wide handling of all dismantled equipment for packing and shipping
  • Full project management with more than 80 operatives on site at its peak
  • Deployment of 450T Hydraulic Gantry, 400T Hydraulic Gantry, Versa Lift and a Container Reach Stacker


GR Engineering Services

Following on from the canning plant installation, we were contracted with the complete installation of a £4.6m tungsten and tin processing plant in Plymouth.

Our scope of works included:

  • Full project management and CDM management
  • Erection of building steelwork and cladding
  • Receipt, handling and installation of all processing plant
  • Rigging and lifting containment
  • Installation of electrical containment
  • Installation of steel, plastic and stainless pipework from 12mm to 900mm diameter
  • Pre-Fabricated and site run pipework

Zeptejte se ještě dnes

Chcete-li pomoct s vaším projektem, zavolejte nám na …

Spojené Království +44 1257 441111

Polsko +48 530 250 500

Německo +49 201 894 5057